Piglog 105 in vivo lean meat rate meter useDescription

1: The picture above shows the display of this device.

2: the outer box of this equipment is made of stainless steel, which can prevent the protection of external collision.

3: There is a black rectangle with keys in the box, which is the setting panel for testing. There is a black line at the interface of the panel and a tester at the tail of the black line. This tester is used to measure the lean meat percentage of the living body.

4: There are rechargeable batteries and chargers in the box. The battery is installed in the control panel. When there is no electricity, remove the battery and install it on the charger for charging. The positive and negative poles should be clearly separated during charging, otherwise the battery cannot be charged. The charging time is 10-14 hours.

5: When we open the box, we can clearly see that there is a bottle of liquid in the box. This liquid-like item is the liquid applied to the measuring probe during measurement. It should be coated with a little bit every time it is measured, and it should be sealed and placed after use.

6: The measurement method looks at the picture above. The measurement method is very simple. Take out the black panel, install the battery, turn on the switch, apply the liquid on the measurement probe, and the measurement probe stays on the back of the pig for about 3 seconds. The measured data will be displayed on the panel.
The above isPiglog 105 in vivo lean meat rate meter useDescription, It only takes a few steps to understand clearly, the operation is also very simple, it is not complicated to use, and it is easy to learn the measurement method.